Anyone worked on a case / STL for the 5 inch astrotouch?
would this work?
We designed that case exactly for that reason 
The link above is broken, would love to get the case but don’t know if that would be compaitable with my screen.
I have the screen listed here:
https://www.jaycar.com.au/5-inch-touchscreen-with-hdmi-and-usb/p/XC9024
@Daniel your website is down.
@Frank it looks like about the correct screen. They should have the website back up soon.
Thanks for letting us know. They joys of AWS maintenance reboots 
3DaGoGo is back online.
We use uptime, they have a free version too.
Just seen the design, don’t think this will suit my screen as the hdmi is at the top on my screen and not on the right side.
Also the lcd uses the GPIO pins as well as the hdmi link from pi to screen to display on screen.
Also on another topic, do you know if this camera is compaitable with AstroPrint.
https://www.jaycar.com.au/5mp-night-vision-camera-for-raspberry-pi/p/XC9021
This the HW that we test with for the touch: https://astroprint.zendesk.com/hc/en-us/articles/360000761606-Step-1-Hardware-requirements-for-the-AstroBox-Touch
The cameras are here: https://astroprint.zendesk.com/hc/en-us/articles/203050005-What-cameras-can-I-connect-to-the-AstroBox-Touch-and-Gateway-
If your HW is not on these lists it means we haven’t tested it and can’t give support for it. However it might still work but you might need to install drivers or make other configurations.
Ok well I’ll give the camera a go, if I have to install drivers, how do I do that on the touch?
I do not have one of mine open, but I think the screen may work, it looks like mine and the hdmi uses a similar jumper.
The camera likely will work, they are all very familiar but you may need a longer cable. And that case is not designed for a flat cable camera but should work.
I have 7 of the 5 inch screens here, really love them, but those screen and camera prices on that website are insane.