This section is for all your Q&A’s around using the AstroBox software.
This could relate to building your own AstroBox, navigating the interface, bugs, etc.
Note: The AstroBox software is what runs on your AstroBox, Raspberry Pi, or pcDuino. This is separate from the AstroPrint Cloud Service. The AstroPrint Cloud Service is what you see and interact with at AstroPrint.com (i.e. cloud slicing, file storage, etc.). If you have questions about what is going on on AstroPrint.com, please post those questions in the AstroPrint Cloud Service Troubleshooting category.
Thanks!