So I updated to the most recent versions for Astroprint Touch…
Began a 35 hour print…about an hour in the display stopped changing and is stuck showing layer 5 and 34 hours
remaining…the Printer continues to print…print looks ok…I am afraid to touch the astrobox for fear it might stop now after 28 hours…but just thought I would post this.
web status shows correctly…I haven’t tried connecting to the box again not sure what will happen.
Edit: Printer completed job…came out pretty good…Touch interface did never updated
Started a new job…and strangely web interface the camera display didn’t refresh and remain stuck on the last image…log out and back and now I see the new print…I am not home to check want the Touch panel shows.