Hello, I have a few meshes set up and am trying to slice with a brim, but the brim is only printing around the first piece and not the others. Settings are below.
Here is a photo of the start of the print.
Any recommendations?
Thanks!
- Slicing Software Cura
- Layer Height 0.1 mm
- First Layer Height 0.3 mm
- First Layer Width Factor 100 %
- Shell Thickness 1 mm
- Solid Top Yes
- Solid Bottom Yes
- Fill Density 15 %
- Bottom/Top Thickness 1 mm
- Print Speed 30 mm/s
- Infill Speed 70 mm/s
- Bottom Layer Speed 20 mm/s
- Number of Skirt Lines 1
- Skirt Minimal Length 300 mm
- Number of Brim Lines 20
- Support Touching Build Plate
- Support Type Lines
- Support Angle 70 °
- Platform Adhesion Brim
- Support For Dual Extrusion Both
- Filament Diameter 1.75 mm
- Filament Flow 100 %
- Print Temperature 220 °C
- Print Bed Temperature 0 °C
- Enable Fan Yes
- Minimum Layer Cooling Time 12 secs
- Minimum Cooling Feedrate 7 mm/s
- Enable Retraction Yes
- Enable Combing All
- Wipe Tower No
- Ooze Shield No
- Cooling Head Lift No
- Infill prints after perimeters No
- Spiral Vase No
- Only follow mesh surface No
- Nozzle Size 0.4 mm