Bug in camera initialization

AstroBox Troubleshooting
#1

This behavior began at some point in the last few months, can’t specify which update. When selecting any option for print capture (every layer, 1 minute, etc.), there’s an error banner (“There was an error adjusting your print capture”), and no capture is made. If I then select “off”, and make my selection again, the print capture works properly.

I’ve seen this behavior with multiple cameras, currently a PS3 eye, and initially changed cameras assuming it was a hardware issue.

Clipboard01.jpg1920×1080 830 KB

#2

Do you have then latest version of the AstroBox 0.10(11)?

What’s the model number of your PS3? There are problems with some

#3

Currently v0.10(11), but the behavior has persisted under multiple versions. I was initially using a cheap generic camera which worked fine for quite some time, until this issue popped up. I swapped through a couple of other cheap generics trying to fix it before I tried the PS3, which leads me to suspect it isn’t the camera itself.