First use massive over extrusion on first layer


#1

Hi,

I am a new user of astroprint. I have installed the plugin on my Octopi installation and linked it to my account. I added my printer (Prusa i3 MK2.5, I added as a MK2 as they are interchangeable in all other programs I have used) I then added PLA with the default PLA profile and started a test print. When performing the test print the first layer started to force so much fillament out that the first layer was creating huge blobs. Not normal behavior for first layer. What could I have done wrong? The attached picture is of the first perimeter, sorry, had already peeled it off the bed when I took the photo.


#2

Hi,

Is it possible that nobody has any clue what’s going on here with this print?