Astroprint 0.1.0(0)
Robo 3D R1 Plus
Losing serial connection and causing failed prints.
I have in advanced settings to save the serial logs but no logs are being saved. /var/log/astrobox
I can see the astrobox.log and the serial.log but serial.log is empty and the only thing in astrobox.log is
2016-10-24 00:59:36,026 - astroprint.camera.v4l2.gstreamer - INFO - Camera not found… retrying 1 times
2016-10-24 00:59:37,029 - astroprint.camera.v4l2.gstreamer - INFO - Camera not found… retrying 2 times
2016-10-24 00:59:38,031 - astroprint.camera.v4l2.gstreamer - INFO - Camera not found… retrying 3 times
2016-10-24 00:59:39,035 - astroprint.camera.v4l2.gstreamer - INFO - Gstreamer’s pipeline memory cleaned
These logs occur in the beginning of the print long before the disconnect. I have replaced the USB cable and hot glued the USB cable in place to help aviod movement of the connector on both ends.
Any suggestions? Seems to have started with 0.10(0).
It seems that you firmware might be buggy? Everytime the printer receives a G90 command it responds with an error:
2016-10-24 01:41:02,036 - SERIAL - DEBUG - Send: G90
2016-10-24 01:41:02,037 - SERIAL - DEBUG - Recv: ok
2016-10-24 01:41:02,053 - SERIAL - DEBUG - Recv: Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)
I haven’t seen this before. G90 are pretty standard. Can you look into updating the firmware to something that’s nota beta or alpha version?
Sorry it took me so long to reply. I haven’t changed the firmware since I got the printer in February. I don’t think there has been any updates to the firmware but I will check. Any other suggestions?