Is there a way to do Manuel bed leveling within Astroprint. I noticed I’m able to pull of small print with no issues but larger models always fail. I’m guessing my build plate is too uneven to reply on 3 point cal. 7 point should improve things… any feedback any thoughts…
Did you find a solution?
I am afraid I don’t have a sufficient answer to your question.
Also, if you are using Astroprint in some manner to level the bed, it’s not really manual leveling…
The obvious question is, what kind of a printer is it?
Perhaps someone can help you better 
P.S: @Josh is the king of bed leveling in our office…