Hello Again
So I’ve come across a new issue. Every time I pause a print, move the print head to say change the filament colour, then restart the print, it moves at a crawl. Not sure if this is a known issue or not.
Thanks
You know I thought this was normal behavior…
@Jonathan_MacIntyre / @Anthony —
No, this should not be normal behavior.
Are you guys both running v0.8(4) on your Astrobox?
Same issue here running latest v0.8(6), I waited a few minutes and then manually sped up the printer to 300% in 50% increments after a pause to fix a filament break. I have a Prusa i3 latest 2.2.4 firmware.