Progress difference in display and app

AstroBox Troubleshooting
#1

Hi there,

I have a wanhao duplicator 4, earlier I printed with the left extruder (uploading gcode with local site) and everything worked fine. I now switched to the right extruder, since that one is displayed (temperature etc).

The problem I have is that the progress on the display of the printer (for example 88% on the printer) is not the same as in the astroprint software (APP, 77%) this isn’t a big deal itself. But as soon as it reaches 100% on the printer it stops printing, even when it’s not actually done yet… I already restarted the raspberry pi 3 and took out the power from the printer.

I don’t really know how I can solve this problem, I hope someone has some suggestions :wink:

Bram

#2

How did you slice the file?

#3

I sliced it in the makerbot software, the same as I did before.
Printing with an sd card instead of the raspberry pi with astroprint works fine

#4

it might be a problem with the printer itself after all, had a succesfull print from the SD card yesterday. but printed something else this night and that print stopped earlier… will look intro it tomorrow and try to do anonther test to see if I can find the problem, or atleast if it’s something with the printer itself or not. Will also try another computer to slice it (since my software is also updated which might be the problem…)

Changed a bit too much at a I time to know the problem already I guess…