Folks, I just got a RP3, and I can’t seem to get a response from the 10.10.0.1 address. All I have is a Red light on the board.
I built the image per instructions, and I checked to see that the image was written.
Thoughts?
We do not yet support the pi3. It’s coming though
I realize this was from March '16 … wasn’t sure if you’d seen a working answer, which is: add a WiFi dongle (such as EDIMAX) and it works right away. I am not sure why, but apparently drivers for the build-in WiFi are hard to “multiplex” (allow multiple WiFi connections).