Raspberry Pi Zero Trouble

AstroBox Questions
#1

Hi -
I have a Printrbot Metal Simple and I wanted connect it to my Pi Zero. So I bought a Edimax Wifi Dongle and I installed the firmware like the instructions say. Then I saw the wifi network created “astrobox-xxxx.” But when I plugged in my PSM it still says there is no printer found. I am using a USB 2.0 hub and the wifi dongle seems to work fine. I have reinstalled the firmware at least 4 times and still get the same results

What should I do?

Nate

#2

We have not really tested with the Zero so I can’t yet say that we support it.

#3

I actually was able to fix this, I believe I had flashed the firmware wrong, but I can confirm that it does work on the RPI Zero.

1 Like