Hi,
so after a week of use I broke my first micro SD card. I have the box to remotely check on my printer from home but I only have a wifi controlled plug to shut the whole system of. This and the “turn on turn off” resetting behavior that I had to perform because the wifi connection in my office isnt the most stable, killed the card.
After researching a bit I read that this happens to micro sd cards because there is no memory controller like in a usb stick that could prevent that. Is there a simple way of configuring the SD card as read only and dumping all data traffic onto an extra usb stick that doesn require deep knowledge of the astro print OS?
Cheers