Slicing issues : cannot slice using Cura

AstroPrint Cloud Service Troubleshooting
#1

Since yesterday, I can’t slice online. So using the online service for my astrobox (pi 3) doesn’t work, and I have to slice it using a PC then send to the local astrobox.

The error is the latter : ‘ascii’ codec can’t decode byte 0xc3 in position 39: ordinal not in range(128)

Thanks a lot for the software :smile: and hope you find the issue

#2

The online slicer is working fine. It might have to do with your STL? How are you slicing?

#3

Sorry for bothering you; the issue was quite simple.
The carriage returns in the begining and end print commands were strange for the slicer.
Problem solved. Thanks a lot for the great support and sorry if this was dumb

1 Like