does this firmware ugrade allow Astroprint to control a Wyze Camera for print captures?
I wrote about that firmware a week ago.
It works with octoprint. It should work with just about anything.
1 Like
I can confirm, the wyze firmware works perfectly with astroprint. Plug and play after you throw the updated firmware on the camera. However, you will need a usb-A to usb-A cable like these: https://www.amazon.com/dp/B07DNMKVSL/ref=cm_sw_r_cp_api_i_gm5LEbEPKQSRH
The raspberry pi will power the camera just fine over that one USB cable so nothing has to be plugged into the micro usb power port on the camera.
1 Like