[SOLVED] Flashforge Creator Pro Default Settings and Scaling Problems


Hi there,
The default profile for Flashforge Creator Pro printer sets the steps/mm to 88.88888, but this is only correct for the Creator, not the pro.
Could the default setting for this printer be updated to have the 94.1176470588 that it should be for this model with only 17 teeth on the pulley not 18.
Otherwise, the prints come out significantly smaller than they should!
Many thanks


The Creator Pro system profile has steps/mm 94.5906 (base on calibration tests) . Where do you get your number? Can you send a screenshot?


Thanks for reporting this. This is now fixed. Please remove the old printer and re-add to get the proper value